PACKAGE GRAPHICS GUIDELINES
High-resolution logos in various color breaks can be viewed and downloaded here.
- Do not scan and reproduce the logo
- Do not re-create the logo
- Do not alter the logo in any way
- Do not use tints or screens
- Use only approved colors
Required color breaks are PMS 186
and Black as shown.
Size and Location of
ZIP-PAK® logo
The ZIP-PAK® logo must appear on the front face of the package, in type no smaller than 5/16" in height, when the area from zipper to top of package is 1" on each side. In areas where the zipper to top-of the package space is smaller, the type size can be slightly reduced but must remain at the same proportion as 5/16" to 1".
The use of the Zip-Pak logo is standard worldwide and can not be altered or translated into other languages.
Text References
When used in text to describe the resealable feature, the word Zip-Pak must always appear in all capitals letters, with the registered trademark on the upper right-hand shoulder of the text, as shown here:
ZIP-PAK®
Trademark Reference Line
The following trademark reference line must always appear somewhere on the package in legible type:
ZIP-PAK® , the ZIP-PAK logo ® and the Color Line Design ® are registered
trademarks of ITW.
Guidelines for Zipper Tape only:
- Prior to artwork development, customer-initiated engineering drawings must always be submitted for approval.
- Final engineering drawings, as mutually approved by Zip-Pak and the customer, are to be used as a basis for all artwork development.
- All perforation marks or cut lines printed on the m must be placed not less than 1/8" below the top edge of the lip area.
- Printed text on the exterior package must be positioned not less than 1/4" below the bottom edge of the closed zipper feature.